AOR AR5001D Guide de l'utilisateur télécharger pdf (Page 95)

Troubleshootin

SCREEN CAPTURE

A jpeg or gif image of the screen may be captured by selecting Save Screen... from the File menu.

RUNNING SIGNALTRACK FROM THE COMMAND LINE

SignalTrack can be run from the command line and immediately switched into the run mode if

desired. The command line format is as follows:

C:\Program Files\Doppler Systems\SignalTrack\SignalTrack.exe [/R] ["mission file path"]

The /R and mission file path are optional. /R will cause the program to switch to the run mode after

it is initialized. The mission file path will cause the specified mission file to be used. If this is not

specified then the last run mission file will be used.

Most operational problems in SignalTrack can be traced to improper setup of the equipment or the

software. This section will outline some techniques you can use to check your setup and determine

if the equipment is providing the necessary data to SignalTrack

TROUBLESHOOTING

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 119 120

Pas de commentaire

AOR AR5001D Guide de l'utilisateur Page 95