AOR AR5001D Guide de l'utilisateur télécharger pdf (Page 42)

SignalTrack User's Guide

USING AN AOR AR5001D

SignalTrack will work with an AOR5001D; however, some addional configuration of the receiver and

the direction finder is required. The receiver baud rate must be changed to 9600 baud and the

communications port on the direction finder must be changed to 9600 baud.

AOR5001D

 Press the FUNC key followed by the MHz key

 Use the Down button to scroll down to BPS

 Turn the knob on the lower right of the receiver until the rate reads 9600

 Press the MHz button.

DDF 6001

 Launch WinRDFCommand and connect to the direction finder per the WinRDFCommand

instructions.

 Once connected change the Port 2 radio button control to AOR RX.

 Next use the Port Parameters menu to set the baud rate to 9600

 Quit WinRDFCommand

 Before running SignalTrack make sure the AOR AR5001D is connected to serial port

connector J2 on the back of the DDF 6001.

DDF6002

 Launch AutoDFTest and connect to the direction finder per the AutoDFTest instructions

 Once connected go to the Port 4 menu and change the baud rate to 9600.

 Quit AutoDFTest

 Before running SignalTrack make sure the AOR AR5001D is connected to serial port

connector J12 on the back of the DDF 6002.

CONFIGURATION WIZARD

After installing SignalTrack, connect the direction finder, receiver, and any networking components

required to network in other sites (if needed). Power up all components and then launch

SignalTrack. The first time you launch SignalTrack the Configuration Wizard will automatically start.

The options selected during this process will configure SignalTrack as a Network Control Site (NCS),

a fixed site direction finder, or a mobile direction finder.

The first dialog to be displayed is the New Mission dialog. Select Blank Fixed Site Mission if you are

configuring a Network Control Site or a fixed sit with a single direction finder. Select Blank Mobile

Site Mission if you are configuring a mobile site.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 119 120

Pas de commentaire

AOR AR5001D Guide de l'utilisateur Page 42