AOR AR2700 Manuel d'utilisateur télécharger pdf (Page 14)

- 14 -

The command SGx[ï] causes an automatic response and searching from the specified bank

where x = 0 ~ 9.

Related commands LC MG SS é ê

Set code for option ON / OFF (not available in the UK).

The SI command is used to review and select the optional code unit On / Off if the option is fitted to the

AR2700.

To review the current status use the command SI[ï]

The response will be in the format SIn

where

n = 0 Optional code unit OFF

n = 1 Optional code unit ON

To switch the code option ON / OFF use the format SIn[ï]

where

SI0[ï] = Optional code unit OFF

SI1[ï] = Optional code unit ON

Related command SC

Set the lower frequency of a search bank.

This command cannot be used on its' own but must be used in conjunction with the SE command, please

refer to the section on SE.

SL Lower frequency limit nnnnnnnnm0 (Hz)

nnnn.nnnnm (MHz)

m = "0" or "5" (tens of Hz position), "5" is only used when the step size is 6.25 kHz. Any entry other

than "0" or "5" will be ignored.

Related commands SE SL SU TT

Recall search data.

The SR command is used to recall search data for a chosen bank.

To recall the search data from the currently selected search bank use the format

SR[ï]

To recall the search data from a specific bank use the format SRx[ï]

where x = search bank 0 ~ 9.

A typical response may be: SRC_SL0118500000_SU0135900000_ST025000_AU1_MD2_AT0

This is a data breakdown of:

Search bank C

Lower (start) frequency 118.50 MHz

Upper (end) frequency 135.90 MHz

Automode ON (this means that mode & step are ignored so

do not have to be specified as will be taken

from the receivers preprogrammed data)

Attenuator OFF

Related command SE

SI SL SR

1 2 ... 9 10 11 12 13 14 15 16

Pas de commentaire

AOR AR2700 Manuel d'utilisateur Page 14